RSS Feed
Knowledgebase : Fleet Broadband > ADU
 


“ID 02603-0 Antenna failure” after replacing ATM board in a Fleat Broadband 500 system.In the new ATM board is added support for a new accelerometer type,which was introduced in a new version of the ATM hardware.That requires BDU software ver. 1.13 or abo...
"602:10 ATM calibration invalid" failed after replacing the ATM PCB. BDU software v1.12 contains ATM sw v1.10BDU software v1.13 contains ATM sw v1.20In ATM sw v1.20 (ie. BDU v1.13) we added support for a new accelerometer type,which was introdu...
Antenna calibration failed: The zero reff. is failing. The sensor is located next to the pedestal. When the antenna panel is in 0 elevation and 0 azimuth two red led on the sensor board shall illuminate. ( Sensor OK. Look at the sensor doing power...
 IMU sensor range check failed The 'IMU sensor range check failed' may occur when the antenna is subject to mechanical motion beyond what the motion sensors can measure reliably (shock, vibration, etc.). In general this will occur now and then. Howeve...
The serial number in the 'WEB MMI->Settings'  reads 0 after replacing the HPA with a spare. The only purpose of the antenna serial number (aka Unit Serial Number for the antenna) is to make us able to refer to a certain specific antenna. The numbe...
Knowledge base – Problems/solutionsDate: January - 2009  Product Name & Type:Product name: FleetBroadband 500, FB500 T&T type number. TT-3052A Hardware / Software version affected: ALL  Subject:It has been found that some TT-3052A ADU...
Help Desk Software by Kayako Fusion