Knowledgebase
Temperature sensor on 6081 charger
Posted by Torben Pedersen on 27 July 2011 07:56 AM
When you install the temperature sensor on a 'double charger' solution you will only need 1 sensor installed on the primary charger.
The temperature information will then be forwarded via the cross link to control both chargers.
If two sensors is fitted the system will act towards the sensor giving the most extreme value, giving lowest value of the two if under 20 degrees Celsius alternatively highest value of the two if above 20 degrees Celsius.
Installation of temperature sensor is urgent to make sure to have best possible battery maintenance.
(1617 vote(s))
This article was helpful
This article was not helpful

Comments (0)
Help Desk Software by Kayako Fusion